Micron M25P40 Serial Flash Embedded Memory
WRITE STATUS REGISTER
Table 7: Status Register Protection Modes (Continued)
Memory Content
W#/VPP
Signal
SRWD
Bit
Protection
Mode (PM)
Status Register
Write Protection
Protected
Unprotected
Area
Area
Notes
0
1
HARDWARE
PROTECTED mode
(HPM)
Hardware protection
Commands not
accepted
Commands
accepted
3, 4, 5,
1. Software protection: status register is writable (SRWD, BP2, BP1, and BP0 bit values can
be changed) if the WRITE ENABLE command has set the WEL bit.
Notes:
2. PAGE PROGRAM, SECTOR ERASE, AND BULK ERASE commands are not accepted.
3. PAGE PROGRAM and SECTOR ERASE commands can be accepted.
4. Hardware protection: status register is not writable (SRWD, BP2, BP1, and BP0 bit values
cannot be changed).
5. PAGE PROGRAM, SECTOR ERASE, AND BULK ERASE commands are not accepted.
When the SRWD bit of the status register is 0 (its initial delivery state), it is possible to
write to the status register provided that the WEL bit has been set previously by a WRITE
ENABLE command, regardless of whether the W#/VPP signal is driven HIGH or LOW.
When the status register SRWD bit is set to 1, two cases need to be considered depend-
ing on the state of the W#/VPP signal:
• If the W#/VPP signal is driven HIGH, it is possible to write to the status register provi-
ded that the WEL bit has been set previously by a WRITE ENABLE command.
• If the W#/VPP signal is driven LOW, it is not possible to write to the status register even
if the WEL bit has been set previously by a WRITE ENABLE command. Therefore, at-
tempts to write to the status register are rejected, and are not accepted for execution.
The result is that all the data bytes in the memory area that have been put in SPM by
the status register block protect bits (BP2, BP1, BP0) are also hardware protected
against data modification.
Regardless of the order of the two events, the HPM can be entered in either of the fol-
lowing ways:
• Setting the status register SRWD bit after driving the W#/VPP signal LOW
• Driving the W#/VPP signal LOW after setting the status register SRWD bit.
The only way to exit the HPM is to pull the W#/VPP signal HIGH. If the W#/VPP signal is
permanently tied HIGH, the HPM can never be activated. In this case, only the SPM is
available, using the status register block protect bits (BP2, BP1, BP0).
PDF: 09005aef8456654f
m25p40.pdf - Rev. Y 8/12 EN
Micron Technology, Inc. reserves the right to change products or specifications without notice.
25
© 2011 Micron Technology, Inc. All rights reserved.
MICRON [ MICRON TECHNOLOGY ]
