Table 4-16 Reset Mode Selection
Mode Select Pin
DATA0
DATA1
Default Function
(Pin Left High)
CSBOOT 16-Bit
CS0
CS1
CS2
CS3
CS4
CS5
CS6
CS[7:6]
CS[8:6]
CS[9:6]
CS[10:6]
DSACK[1:0],
AVEC, DS, AS,
SIZE
IRQ[7:1]
MODCLK
Test Mode Disabled
VCO = System Clock
Background Mode Disabled
Alternate Function
(Pin Pulled Low)
CSBOOT 8-Bit
BR
BG
BGACK
FC0
FC1
FC2
ADDR19
ADDR[20:19]
ADDR[21:19]
ADDR[22:19]
ADDR[23:19]
PORTE
DATA2
DATA3
DATA4
DATA5
DATA6
DATA7
DATA8
DATA9
PORTF
Test Mode Enabled
EXTAL = System Clock
Background Mode Enabled
4
DATA11
MODCLK
BKPT
4.6.3.1 Data Bus Mode Selection
All data lines have weak internal pull-up drivers. When pins are held high by the inter-
nal drivers, the MCU uses a default operating configuration. However, specific lines
can be held low externally to achieve an alternate configuration.
NOTE
External bus loading can overcome the weak internal pull-up drivers
on data bus lines, and hold pins low during reset.
Use an active device to hold data bus lines low. Data bus configuration logic must re-
lease the bus before the first bus cycle after reset to prevent conflict with external
memory devices. The first bus cycle occurs ten CLKOUT cycles after RESET is re-
leased. If external mode selection logic causes a conflict of this type, an isolation re-
sistor on the driven lines may be required.
shows a recommended method
for conditioning the mode select signals.
MOTOROLA
4-38
SYSTEM INTEGRATION MODULE
MC68331
USER’S MANUAL
MOTOROLA [ MOTOROLA, INC ]
