FEDD51V17805F-02
1
Semiconductor
MSM51V17805F
Notes: 1. A start-up delay of 200µs is required after power-up, followed by a minimum of eight initialization
cycles (RAS-only refresh or
CAS
before
RAS
refresh) before proper device operation is achieved.
2. The AC characteristics assume t
T
= 2ns.
3. V
IH
(Min.) and V
IL
(Max.) are reference levels for measuring input timing signals. Transition times (t
T
)
are measured between V
IH
and V
IL
.
4. -50 is measured with a load circuit equivalent to 1 TTL load and 50pF, and -60/-70 is measured with a
load circuit equivalent to 1 TTL load and 100pF.
5. Operation within the t
RCD
(Max.) limit ensures that t
RAC
(Max.) can be met.
t
RCD
(Max.) is specified as a reference point only. If t
RCD
is greater than the specified t
RCD
(Max.) limit,
then the access time is controlled by t
CAC
.
6. Operation within the t
RAD
(Max.) limit ensures that t
RAC
(Max.) can be met.
t
RAD
(Max.) is specified as a reference point only. If t
RAD
is greater than the specified t
RAD
(Max.) limit,
then the access time is controlled by t
AA
.
7. t
CEZ
(Max.), t
REZ
(Max.), t
WEZ
(Max.), and t
OEZ
(Max.) define the time at which the output achieved the
open circuit condition and are not referenced to output voltage levels.
8. t
CEZ
, and t
REZ
must be satisfied for open circuit condition.
9. t
RCH
or t
RRH
must be satisfied for a read cycle.
10. t
WCS
, t
CWD
, t
RWD
, t
AWD
and t
CPWD
are not restrictive operating parameters. They are included in the data
sheet as electrical characteristics only. If t
WCS
≥
t
WCS
(Min.), then the cycle is an early write cycle and
the data out will remain open circuit (high impedance) throughout the entire cycle. If t
CWD
≥
t
CWD
(Min.), t
RWD
≥
t
RWD
(Min.), t
AWD
≥
t
AWD
(Min.) and t
CPWD
≥
t
CPWD
(Min.), then the cycle is a read modify
write cycle and data out will contain data read from the selected cell; if neither of the above sets of
conditions is satisfied, then the condition of the data out (at access time) is indeterminate.
11. These parameters are referenced to the
CAS,
leading edges in an early write cycle, and to the
WE
leading edge in an
OE
control write cycle, or a read modify write cycle.
9/17
OKI [ OKI ELECTRONIC COMPONETS ]
