¡ Semiconductor
XSYNC
MSM7705-01/02/03
Transmit synchronizing signal input.
PCM output signal from the DOUT1, DOUT2, DOUT3, and DOUT4 pins is output in
synchronization with this transmit synchronizing signal. This synchronizing signal triggers the
PLL and synchronizes all timing signals of the transmit section.
This synchronizing signal must be synchronized in phase with BCLK.
The frequency should be 8 kHz
±50
ppm to guarantee the AC characteristics which are mainly
the frequency characteristics of the transmit section.
However, this device can be operated in the range of 6 kHz to 10 kHz unless the frequency
characteristics of the system used are strictly specified, but the electrical characteristics are not
guaranteed.
Setting this signal to logic "1" or "0" drives both transmit and receive circuits to power saving
state.
DOUT1
PCM signal output of channel 1 when the parallel mode is selected.
The PCM output signal is output from MSD in a sequential order, synchronizing with the rising
edge of the BCLK signal.
MSD may be output at the rising edge of the XSYNC signal, based on the timing between BCLK
and XSYNC.
This pin is in a high impedance state except during 8-bit PCM output. It is also in a high
impedance state during power-saving state or power-down state.
When the serial mode is selected, this pin is configured to be the output of serial multiplexed 4ch
PCM signal.
A pull-up resistor must be connected to this pin because it is an open drain output.
This device is compatible with the ITU-T recommendation on coding law and output coding
format.
The MSM7705-03 (A-law) outputs the character signal, inverting the even bits.
PCMIN/PCMOUT
MSM7705-02 (m-law)
MSD
+Full scale
+0
–0
–Full scale
1 0 0 0
1 1 1 1
0 1 1 1
0 0 0 0
0 0 0 0
1 1 1 1
1 1 1 1
0 0 0 0
MSM7705-03 (A-law)
MSD
1 0 1 0
1 1 0 1
0 1 0 1
0 0 1 0
1 0 1 0
0 1 0 1
0 1 0 1
1 0 1 0
Input/Output Level
6/20
OKI [ OKI ELECTRONIC COMPONETS ]
