PI5A4684
Chip Scale Packaging,
Dual SPDT Analog Switch
Absolute Maximum Ratings
(1)
Supply Voltage V
CC
............................................ –0.5V to +7V
DC Switch Voltage (V
S
)
(2)
........................ –0.5V to V
CC
+0.5V
DC Input Voltage (V
IN
)
(2)
................................ –0.5V to +7.0V
Continuous Current
NO_NC_COM_
.............................. ±500mA
Peak Current
NO_NC_COM_
(pulsed at 1ms 50% duty cycle) ............................... ±650mA
Peak Current
NO_NC_COM_
(pulsed at 1ms 10% duty cycle) ............................... ±800mA
Storage Temperature Range (T
STG
) .............. –65°C to +150°C
Junction Temperature under Bias (T
J
) .............................150°C
Junction Lead Temperature (T
L
)
(Soldering, 10 seconds) ................................................260°C
Power Dissipation (P
D
) @ +85°C .................................. 250mW
Recommended Operating Conditions
(3)
Supply Voltage Operating (V
CC
) . . . . . . . . . . . . 1.65V to 5.5V
Control Input Voltage (V
IN
) . . . . . . . . . . . . . . . . . . . 0V to V
CC
Switch Input Voltage (V
IN
) . . . . . . . . . . . . . . . . . . . . 0V to V
CC
Output Voltage (V
OUT
) . . . . . . . . . . . . . . . . . . . . . . . 0V to V
CC
Operating Temperature (T
A
) . . . . . . . . . . . . . . . –40°C to +85°C
Input Rise and Fall Time (t
r
,t
f
)
Control Input V
CC
= 2.3V - 3.6V. . . . . . . . . 0ns/V to 10ns/V
Control Input V
CC
= 4.5V - 5.5V. . . . . . . . . . 0ns/V to 5ns/V
Thermal Resistance (θ
JA
) . . . . . . . . . . . . . . . . . . . . . . 350°C/W
Lead Temperature (soldering 10s) . . . . . . . . . . . . . . . . . +300°C
Bump Temperature (soldering notes)
Infared (15s). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +220°C
Vapor Phase (60ns) . . . . . . . . . . . . . . . . . . . . . . . . . . +215°C
Notes:
1. "Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any
other conditions beyond those indicated in the operational sections of this specification is not implied.
2. The input and output negative voltage ratings may be exceeded if the inut and output diode current ratings are observed.
3. Control input must be held HIGH or LOW; it must not float.
06-0062
2
PS8792B
05/09/06
PERICOM [ PERICOM SEMICONDUCTOR CORPORATION ]
