Si1010/1/2/3/4/5
21.1. Port I/O Modes of Operation
Port pins P0.0–P1.6 use the Port I/O cell shown in Figure 21.2. Each Port I/O cell can be configured by
software for analog I/O or digital I/O using the PnMDIN registers. On reset, all Port I/O cells default to a dig-
ital high impedance state with weak pull-ups enabled.
21.1.1. Port Pins Configured for Analog I/O
Any pins to be used as Comparator or ADC input, external oscillator input/output, or AGND, VREF, or Cur-
rent Reference output should be configured for analog I/O (PnMDIN.n = 0). When a pin is configured for
analog I/O, its weak pullup and digital receiver are disabled. In most cases, software should also disable
the digital output drivers. Port pins configured for analog I/O will always read back a value of 0 regardless
of the actual voltage on the pin.
Configuring pins as analog I/O saves power and isolates the Port pin from digital interference. Port pins
configured as digital inputs may still be used by analog peripherals; however, this practice is not recom-
mended and may result in measurement errors.
21.1.2. Port Pins Configured For Digital I/O
Any pins to be used by digital peripherals (UART, SPI, SMBus, etc.), external digital event capture func-
tions, or as GPIO should be configured as digital I/O (PnMDIN.n = 1). For digital I/O pins, one of two output
modes (push-pull or open-drain) must be selected using the PnMDOUT registers.
Push-pull outputs (PnMDOUT.n = 1) drive the Port pad to the VDD_MCU/DC+ or GND supply rails based
on the output logic value of the Port pin. Open-drain outputs have the high side driver disabled; therefore,
they only drive the Port pad to GND when the output logic value is 0 and become high impedance inputs
(both high and low drivers turned off) when the output logic value is 1.
When a digital I/O cell is placed in the high impedance state, a weak pull-up transistor pulls the Port pad to
the VDD_MCU/DC+ supply voltage to ensure the digital input is at a defined logic state. Weak pull-ups are
disabled when the I/O cell is driven to GND to minimize power consumption and may be globally disabled
by setting WEAKPUD to 1. The user must ensure that digital I/O are always internally or externally pulled
or driven to a valid logic state. Port pins configured for digital I/O always read back the logic state of the
Port pad, regardless of the output logic value of the Port pin.
WEAKPUD
(Weak Pull-Up Disable)
PnMDOUT.x
(1 for push-pull)
(0 for open-drain)
VDD_MCU/DC+
(WEAK)
VDD_MCU/DC+
XBARE
(Crossbar
Enable)
PORT
PAD
Pn.x – Output
Logic Value
(Port Latch or
Crossbar)
PnMDIN.x
(1 for digital)
(0 for analog)
GND
To/From Analog
Peripheral
Pn.x – Input Logic Value
(Reads 0 when pin is configured as an analog I/O)
Figure 21.2. Port I/O Cell Block Diagram
220
Rev. 1.0
SILICON [ SILICON ]
