Multiple RPM-Based PWM Fan Controller
Datasheet
Bit 0 - FAN_STALL - Indicates that one or more fan drivers have stalled. This bit is set when any bit
in the Fan Stall Status register is set and cleared when all of the bits in the Fan Stall Status register
are cleared.
5.3.2
Fan Stall Status - 25h
The Fan Stall Status register indicates which fan driver has detected a stalled condition (see
All bits are cleared upon a read if the error condition has been removed.
Bit 2 - FAN3_STALL - Indicates that Fan 3 has stalled.
Bit 1 - FAN2_STALL - Indicates that Fan 2 has stalled.
Bit 0 - FAN1_STALL - Indicates that Fan 1 has stalled.
5.3.3
Fan Spin Status - 26h
The Fan Spin Status register indicates which fan driver has failed to spin-up (see
All bits
are cleared upon a read if the error condition has been removed.
Bit 2 - FAN3_SPIN - Indicates that Fan 3 has failed to spin up.
Bit 1 - FAN2_SPIN - Indicates that Fan 2 has failed to spin up.
Bit 0 - FAN1_SPIN - Indicates that Fan 1 has failed to spin up.
5.3.4
Fan Drive Fail Status - 27h
The Fan Drive Fail Status register indicates which fan driver cannot drive to the programmed speed
even at 100% duty cycle (see
and
All bits are cleared upon a read if the
error condition has been removed.
Bit 2 - DRIVE_FAIL3 - Indicates that Fan 3 cannot reach its programmed fan speed even at 100% duty
cycle. This may be due to an aging fan or invalid programming.
Bit 1 - DRIVE_FAIL2 - Indicates that Fan 2 cannot reach its programmed fan speed even at 100% duty
cycle. This may be due to an aging fan or invalid programming.
Bit 0 - DRIVE_FAIL1 - Indicates that Fan 1 cannot reach its programmed fan speed even at 100% duty
cycle. This may be due to an aging fan or invalid programming.
5.4
Fan Interrupt Enable Register
Table 5.4 Fan Interrupt Enable Register
ADDR
R/W
REGISTER
Fan
Interrupt
Enable
B7
B6
B5
B4
B3
B2
FAN3_
INT_EN
B1
FAN2_
INT_EN
B0
FAN1_
INT_EN
DEFAULT
29h
R/W
-
-
-
-
-
00h
The Fan Interrupt Enable controls the masking for each Fan channel. When a channel is enabled, it
will cause the ALERT# pin to be asserted when an error condition is detected.
Bit 2 - FAN3_INT_EN - Allows Fan 3 to assert the ALERT# pin if an error is detected.
Bit 1 - FAN2_INT_EN - Allows Fan 2 to assert the ALERT# pin if an error is detected.
Bit 0 - FAN1_INT_EN - Allows Fan 1 to assert the ALERT# pin if an error condition is detected.
Revision 1.1 (10-12-09)
30
SMSC EMC2303
DATASHEET
SMSC [ SMSC CORPORATION ]
