MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX and flexPWR
®
Technology in a Small Footprint
Datasheet
Chapter 3 Pin Description
This chapter describes the signals on each pin. When a lower case “n” is used at the beginning of the
signal name, it indicates that the signal is active low. For example, nRST indicates that the reset signal
is active low. The buffer type for each signal is indicated in the TYPE column, and a description of the
buffer types is provided in
Table 3.1 Buffer Types
BUFFER TYPE
I8
O8
IOD8
IPU
IPD
IOPU
IOPD
AI
AIO
ICLK
OCLK
P
Note 3.1
Input.
Output with 8mA sink and 8mA source.
Input/Open-drain output with 8mA sink.
Input with 67k (typical) internal pull-up.
Input with 67k (typical) internal pull-down.
Input/Output with 67k (typical) internal pull-up. Output has 8mA sink and 8mA source.
Input/Output with 67k (typical) internal pull-down. Output has 8mA sink and 8mA source.
Analog input
Analog bi-directional
Crystal oscillator input pin
Crystal oscillator output pin
Power pin
Unless otherwise noted in the pin description, internal pull-up and pull-down resistors are
always enabled. The internal pull-up and pull-down resistors prevent unconnected inputs
from floating, and must not be relied upon to drive signals external to
LAN8710/LAN8710i
.
When connected to a load that must be pulled high or low, an external resistor must be
added.
DESCRIPTION
Note:
The digital signals are not 5V tolerant.They are variable voltage from +1.6V to +3.6V, as shown
in
3.1
MAC Interface Signals
Table 3.2 MII/RMII Signals 32-QFN
SIGNAL
NAME
TXD0
TXD1
32-QFN
PIN #
22
23
TYPE
I8
I8
DESCRIPTION
Transmit Data 0:
The MAC transmits data to the transceiver using this
signal in all modes.
Transmit Data 1:
The MAC transmits data to the transceiver using this
signal in all modes
14
SMSC LAN8710/LAN8710i
Revision 1.0 (04-15-09)
DATASHEET
SMSC [ SMSC CORPORATION ]
