MII/RMII 10/100 Ethernet Transceiver with HP Auto-MDIX and flexPWR
®
Technology in a Small Footprint
Datasheet
Table 5.27 Register 6 - Auto Negotiation Expansion
ADDRESS
6.15:5
6.4
6.3
6.2
6.1
6.0
NAME
Reserved
Parallel Detection
Fault
Link Partner Next
Page Able
Next Page Able
Page Received
Link Partner Auto-
Negotiation Able
1 = fault detected by parallel detection logic
0 = no fault detected by parallel detection logic
1 = link partner has next page ability
0 = link partner does not have next page ability
1 = local device has next page ability
0 = local device does not have next page ability
1 = new page received
0 = new page not yet received
1 = link partner has auto-negotiation ability
0 = link partner does not have auto-negotiation ability
DESCRIPTION
MODE
RO
RO/
LH
RO
RO
RO/
LH
RO
DEFAULT
0
0
0
0
0
0
Table 5.28 Register 16 - Silicon Revision
ADDRESS
16.15:10
16.9:6
16.5:0
NAME
Reserved
Silicon Revision
Reserved
Four-bit silicon revision identifier.
DESCRIPTION
MODE
RO
RO
RO
DEFAULT
0
0001
0
Table 5.29 Register 17 - Mode Control/Status
ADDRESS
17.15:14
17.13
NAME
Reserved
EDPWRDOWN
DESCRIPTION
Write as 0; ignore on read.
Enable the Energy Detect Power-Down mode:
0 = Energy Detect Power-Down is disabled
1 = Energy Detect Power-Down is enabled
Write as 0, ignore on read
The Low_Squelch signal is equal to LOWSQEN AND
EDPWRDOWN.
Low_Squelch = 1 implies a lower threshold
(more sensitive).
Low_Squelch = 0 implies a higher threshold
(less sensitive).
Management Data Preamble Bypass:
0 – detect SMI packets with Preamble
1 – detect SMI packets without preamble
Force the module to the FAR Loop Back mode, i.e. all
the received packets are sent back simultaneously (in
100Base-TX only). This bit is only active in RMII
mode, as described in
This mode
works even if MII Isolate (0.10) is set.
Write as 0, ignore on read.
MODE
RW
RW
DEFAULT
0
0
17.12
17.11
Reserved
LOWSQEN
RW
RW
0
0
17.10
MDPREBP
RW
0
17.9
FARLOOPBACK
RW
0
17.8:7
Reserved
RW
00
SMSC LAN8710/LAN8710i
43
Revision 1.0 (04-15-09)
DATASHEET