USB 2.0 Hi-Speed 3-Port Hub Controller Optimized for Portable Applications
Datasheet
Note:
All power supplies must have reached the operating levels mandated in
prior to (or coincident with) the assertion of RESET_N.
8.3.3
USB Bus Reset
In response to the upstream port signaling a reset to the device, the device performs the following:
Note:
The device does not propagate the upstream USB reset to downstream devices.
1. Sets default address to 0.
2. Sets configuration to: Unconfigured.
3. Moves device from suspended to active (if suspended).
4. Complies with Section 11.10 of the USB 2.0 Specification for behavior after completion of the
reset sequence.
The host then configures the device in accordance with the USB Specification.
8.4
Reference Clock
The device’s reference clock (REFCLK) input can be driven with a square wave from 0V to VDD33
and is compatible with several different reference frequencies as shown in
The REFSEL[1:0]
inputs must be configured to select the default input reference clock frequency that matches the clock
frequency applied to REFCLK. The REFSEL[1:0] inputs are latched upon entering the HUB.config
stage and are ignored afterward. REFSEL[1:0] settings are provided in
Note:
The frequencies shown for each REFSEL[1:0] combination in
are the default values.
The frequencies associated with each specific REFSEL[1:0] value can be customized to
support other frequencies. Refer to the SMSC Pro-Touch Configuration Tool documentation for
additional information.
Table 8.4 Default Reference Clock Frequencies
REFSEL[1:0]
‘00’
‘01’
‘10’
‘11’
FREQUENCY (MHz)
38.4
26.0
19.2
12.0
Revision 1.0 (06-17-13)
54
SMSC USB3813
DATASHEET
SMSC [ SMSC CORPORATION ]
