SMS64
Preliminary
PIN DESCRIPTIONS
PIN DESCRIPTIONS
Pin
Number
6
5
4
3
2
1
7
10
11
12
Pin
Type
PWR
PWR
PWR
PWR
PWR
PWR
PWR
I
I
I
Pin Name
VCC
A
VCC
B
VCC
C
VCC
D
VCC
E
VCC
F
VCC_CAP
A2
A1
CS#
Pin Description
The VCC inputs have two functions on the SMS64. They are used as the
power supply inputs and as such are diode-OR’ed so that at any point in time the
highest potential input will be the power source for the SMS64. So long as one of
the inputs is at or above 1V the RESET outputs will be active. For proper device
operation, including sequencing, at least one of the pins must be at or above
2.7V.
Each VCC input can be programmed as a voltage sensing input. It will only be
used as a precursor to power-on sequencing. Once it reaches its V
PTH
the
comparator’s source input will be switched to its corresponding VM input.
VCC_CAP is a charge storage connection to the SMS64’s internal power
supply. For most applications this pin is tied to a 10µF capacitor.
The address pins are biased either to VCC_CAP or GND.
When
communicating with the SMS64 over the 2-wire bus these pins provide a
mechanism for assigning a unique bus address. A2 and A1 are internally
connected to VCC through a 100KΩ resistor.
The Chip Select input is used solely for enabling communication on the 2-wire
bus. In order to write or read the registers or the memory array the CS# input
must be low. CS# is internally connected to VCC through a 100KΩ resistor.
The SCL input is used to clock data into and out of the memory array. In the
write mode, data must remain stable while SCL is HIGH. In the read mode, data
is clocked out on the falling edge of SCL.
SDA is the bidirectional serial data pin. It is configured as an open drain
output and will require a pull-up resistor to VCC_CAP or a higher potential system
supply.
GND is the ground for both the analog and digital portions of the internal
circuitry. It is internally tied to pin 24. (Both pins should be tied to system ground).
The force shutdown input is used to immediately turn off all PUP outputs. FS#
is internally connected to VCC through a 100KΩ resistor.
The PWR_ON/OFF input is used to initiate power-on and power-off
sequencing. When the input is high and all of the programmed preconditions are
met, the SMS64 will power-on.
If the input is taken low, the SMS64 will begin the power-off operation. If
programmed to do so, the SMS64 will sequence off the PUP outputs either in the
power-on order or reverse order. PWR_ON/OFF is internally connected to VDD
through a 100KΩ resistor.
MR# is the manual reset input. When MR# is taken low the RST_A# and
RST_B# outputs will be driven low. The RST outputs will stay low so long as the
MR# input is low, and will remain low for t
PRTO
after MR# returns high (so long as
no other reset conditions exist).
MR# must be low in order to write to the configuration registers and
high to
write to the memory array (see descriptions on page 16).
MR# is internally
connected to VCC through a 100kΩ pull-up resistor.
13
I
SCL
14
15
16
I/O
PWR
I
SDA
GND
FS#
17
I
PWR_
ON/OFF
18
I
MR#
Summit Microelectronics, Inc
2060 2.22 10/09/03
4
SUMMIT [ SUMMIT MICROELECTRONICS, INC. ]
