CC1110Fx / CC1111Fx
11.3.6 Stack Pointer
The stack resides in DATA memory space and
grows upwards. The PUSH instruction first
increments the Stack Pointer (SP) and then
copies the byte into the stack. The Stack
Pointer is initialized to 0x07 after a reset and it
SP (0x81) – Stack Pointer
Bit
7:0
Name
SP[7:0]
Reset
0x07
R/W
R/W
Description
Stack Pointer
is incremented once to start from location
0x08, which is the first register (R0) of the
second register bank. Thus, in order to use
more than one register bank, the
SP
should be
initialized to a different location not used for
data storage.
11.4 Instruction Set Summary
The 8051 instruction set is summarized in
©
Intel
Corporation 1980.
The following conventions are used in the
instruction set summary:
•
Rn – Register
R7-R0
of the currently
selected register bank.
•
direct – 8-bit internal data location’s
address. This can be DATA area (0x00
– 0x7F) or SFR area (0x80 – 0xFF).
•
@Ri – 8-bit internal data location, DATA
area (0x00 – 0xFF) addressed indirectly
through register
R1
or
R0.
•
#data – 8-bit constant included in
instruction.
•
#data16 – 16-bit constant included in
instruction.
•
addr16 – 16-bit destination address.
Used by LCALL and LJMP. A branch
can be anywhere within the 8/16/32 KB
CODE memory space.
•
addr11 – 11-bit destination address.
Used by ACALL and AJMP. The branch
will be within the same 2 KB page of
program memory as the first byte of the
following instruction.
•
rel – Signed (two’s complement) 8-bit
offset byte. Used by SJMP and all
conditional jumps. Range is –128 to
+127 bytes relative to first byte of the
following instruction.
•
bit – direct addressed bit in DATA area
or SFR.
The instructions that affect CPU flag settings
located in
PSW
are listed in Table 38 on page
register or
bits in
will also affect the flag settings.
SWRS033E
Page 56 of 239
TAOS [ TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS ]
