TQP3M9009
High Linearity LNA Gain Block
Application Circuit Configuration
Notes:
1. See PC Board Layout, page 8 for more information.
2. Components shown on the silkscreen but not on the schematic are not used.
3. B1 (0
Ω
jumper) may be replaced with copper trace in the target application layout.
4. The recommended component values are dependent upon the frequency of operation.
5. All components are of 0603 size unless stated on the schematic.
Bill of Material
Reference Designation
Q1
C2, C6
C1
L2
D1
B1
1000 pF
0.01 uF
330 nH
Do Not Place
0
Ω
Frequency (MHz)
TQP3M9009-PCB_IF
TQP3M9009-PCB_RF
50 - 500
500 - 4000
TQP3M9009
100 pF
0.01 uF
68 nH
Notes:
1. Performances can be optimized at frequency of interest by using recommended component values shown in the table below.
Reference
Designation
C2, C6
L2
500
100 pF
82 nH
2000
22 pF
22 nH
Frequency (MHz)
2500
22 pF
18 nH
3500
22 pF
15 nH
Data Sheet: Rev G 12/27/11
© 2011 TriQuint Semiconductor, Inc.
-
4 of 10
-
Disclaimer: Subject to change without notice
Connecting the Digital World to the Global Network
®
TRIQUINT [ TRIQUINT SEMICONDUCTOR ]
