EN5339QI
PIN
12
NAME
TST0
FUNCTION
Test Pin. For Enpirion internal use only. Connect to AVIN at all times.
NO CONNECT: This pin must be soldered to PCB but not electrically connected to any other
pin or to any external signal, voltage, or ground. This pin may be connected internally. Failure
to follow this guideline may result in device damage.
This is the external feedback input pin. A resistor divider connects from the output to AGND.
The mid-point of the resistor divider is connected to VFB. A feed-forward capacitor is
required parallel to the upper feedback resistor (R
A
). The output voltage regulation is based
on the VFB node voltage equal to 0.600V.
The quiet ground for the control circuits. Connect to the ground plane with a via right next to
the pin.
Analog input voltage for the control circuits. Connect this pin to the input power supply (PVIN)
at a quiet point. Decouple with a 1uF capacitor to AGND.
POK is an open drain output. Refer to Power OK section for details. Leave POK open if
unused.
Output Enable. A logic high level on this pin enables the output and initiates a soft-start. A
logic low signal disables the output and discharges the output to GND. This pin must not be
left floating.
Input power supply. Connect to input power supply and place input filter capacitor(s) between
these pins and PGND pins 2 to 3.
Not a perimeter pin. Device thermal pad to be connected to the system GND plane for heat-
sinking purposes. See Layout Recommendation section.
13
NC
14
VFB
15
16
17
18
19-20
25,26
AGND
AVIN
POK
ENABLE
PVIN
PGND
©Enpirion
2012 all rights reserved, E&OE
06903
September 12, 2012
www.enpirion.com,
Page 3
Rev:
B
ENPIRION [ ENPIRION, INC. ]
