IN74HC4053A
MAXIMUM RATINGS
*
Symbol
V
CC
V
EE
V
IS
V
IN
I
P
D
Tstg
T
L
*
Parameter
Positive DC Supply Voltage (Referenced to GND)
(Referenced to V
EE
)
Negative DC Supply Voltage (Referenced to GND)
Analog Input Voltage
Digital Input Voltage (Referenced to GND)
DC Input Current Into or Out of Any Pin
Power Dissipation in Still Air, Plastic DIP+
SOIC Package+
Storage Temperature
Lead Temperature, 1 mm from Case for 10 Seconds
(Plastic DIP or SOIC Package)
Value
-0.5 to +7.0
-0.5 to +14.0
-7.0 to +0.5
V
EE
- 0.5 to V
CC
+0.5
-1.5 to V
CC
+1.5
±25
750
500
-65 to +150
260
Unit
V
V
V
V
mA
mW
°C
°C
Maximum Ratings are those values beyond which damage to the device may occur.
Functional operation should be restricted to the Recommended Operating Conditions.
+Derating - Plastic DIP: - 10 mW/°C from 65° to 125°C
SOIC Package: : - 7 mW/°C from 65° to 125°C
RECOMMENDED OPERATING CONDITIONS
Symbol
V
CC
V
EE
V
IS
V
IN
V
IO*
T
A
t
r
, t
f
Parameter
Positive Supply Voltage (Referenced to GND)
(Referenced to V
EE
)
Negative DC Supply Voltage (Referenced to GND)
Analog Input Voltage
Digital Input Voltage (Referenced to GND)
Static or Dynamic Voltage Across Switch
Operating Temperature, All Package Types
Input Rise and Fall Time (Channel Select
or Enable Inputs)
V
CC
=2.0 V
V
CC
=4.5 V
V
CC
=6.0 V
Min
2.0
2.0
- 6.0
V
EE
GND
-
-55
0
0
0
Max
6.0
12.0
GND
V
CC
V
CC
1.2
+125
1000
500
400
Unit
V
V
V
V
V
°C
ns
*
For voltage drops across the switch greater than 1.2 V (switch on), excessive V
CC
current may be drawn;
i. e., the current out of the switch may contain both V
CC
and switch input components. The reliability of the device
will be unaffected unless the Maximum Ratings are exceeded.
This device contains protection circuitry to guard against damage due to high static voltages or electric fields.
However, precautions must be taken to avoid applications of any voltage higher than maximum rated voltages to this
high-impedance circuit. For proper operation, V
IN
and V
OUT
should be constrained to the range indicated in the
Recommended Operating Conditions..
Unused digital input pins must always be tied to an appropriate logic voltage level (e.g., either GND or V
CC
).
Unused Analog I/O pins may be left open or terminated.
Rev. 00