MCP413X/415X/423X/425X
4.2.1.1
Status (STATUS) Register
The STATUS register is placed at Address 05h.
This register contains 5 status bits. These bits show the
state of the Shutdown bit. The STATUS register can be
accessed via the READ commands.
describes each STATUS register bit.
REGISTER 4-1:
R-1
bit 7
Legend:
R = Readable bit
-n = Value at POR
bit 8-5
bit 4-2
bit 1
R-1
STATUS REGISTER
R-1
D8:D5
R-1
R-0
RESV
R-x
RESV
R-x
RESV
R-x
SHDN
R-x
RESV
bit 0
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
D8:D5:
Reserved. Forced to “1”
RESV:
Reserved
SHDN:
Hardware Shutdown pin Status bit (Refer to
for further information)
This bit indicates if the Hardware shutdown pin (SHDN) is low. A hardware shutdown disconnects the
Terminal A and forces the wiper (Terminal W) to Terminal B (see
While the device is in Hard-
ware Shutdown (the SHDN pin is low) the serial interface is operational so the STATUS register may be
read.
1
= MCP4XXX is in the Hardware Shutdown state
0
= MCP4XXX is NOT in the Hardware Shutdown state
RESV:
Reserved
bit 0
DS22060B-page 34
©
2008 Microchip Technology Inc.