650072-000 参数 Datasheet PDF下载

SPECIFICATION CONTROL DRAWING

The test assemblies for qualification testing shall be 3 to 3 in-line splices made in wire conforming

to MIL-W-81044/12 or MIL-W-16878/4. The assemblies shall be divided equally between the maximum

and minimum wire size as shown below:

Assembly

D-436-42

D-436-43

Minimum

24

22

Maximum

22

18

The qualification sample shall consists of 35 assemblies and 8 uninstalled sleeves.

1.1

Acceptance Testing:

Acceptance sampling shall be in accordance with ANSI/ASQC Z1.4, Inspection Level S-4. The

Acceptable Quality Level shall be 4.0 for all defects.

Acceptance tests shall consist of visual and dimensional examination.

2.0

QUALIFICATION TESTING:

.1

All sleeves shall be tested for compliance with Sheet 1 in regard to:

Property

Material and Appearance

Dimensions

2.2

Test Method

Visual Examination

MIL-I-23053, Paragraph 4.6.3

Test Group A: Ten assemblies shall pass the post conditioning tests after conditioning in the

sequence shown:

Post Conditioning

Insulation Resistance

Altitude Immersion

Insulation Resistance

Dielectric Withstanding

Conditioning

Altitude Immersion

Immersion

Temperature Cycling

Moisture Resistance

Fluid Immersion

Heat Aging

Requirement

5000 M @500V d-c

75,000 ft.

5000 M @500V d-c

2.5Kv (rms) for 1 min.

Parameters

75,000 ft.

Condition C

-65C to 150C (5 cycles)

Step 7b not required

MIL-H-5606, MIL-L-7808

96 hours @200C

Test Method

MIL-W-81044, Par. 4.7.5.2

MIL-C-26500, Par. 4.7.21

MIL-W-81044, Par. 4.7.5.2

MIL-W-81044, Par. 4.7.5.1

Test method

MIL-C-26500, Par. 4.7.21

Method 104*

Method 102*

Method 106*

MIL-T-7928, Par. 4.8.8

Method 108*

2.3

Test Group B: Ten Assemblies:

Requirement

TE Connectivity

305 Constitution Drive

Menlo Park, CA 94025, USA

Test Sequence

Test Method

TITLE :

Raychem

Products

DOCUMENT NO.:

DATE:

IN-LINE SPLICE SEALING

SYSTEM, MULTI-WIRE

UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.

INCHES DIMENSIONS ARE BETWEEN BRACKETS.

TOLERANCES:

ANGLES: N/A

TE Connectivity reserves the right to amend this

0.00 N/A

drawing at any time. Users should evaluate the

0.0 N/A

ROUGHNESS IN

suitability of the product for their application.

0 N/A

MICRON

DRAWN BY:

REPLACES:

DCR NUMBER:

D-436-42/-43

DOC ISSUE:

15-Apr-11

PROD. REV.

SCALE:

SIZE:

2

SHEET:

M. FORONDA

N/A

D001303

SEE TABLE

None

A

2 of 4

If this document is printed it becomes uncontrolled. Check for the latest revision.