650072-000 参数 Datasheet PDF下载

SPECIFICATION CONTROL DRAWING

Longitudinal Change

±10%

(5 minutes @ 300C)

MIL-I-23053, Par. 4.6.5.1

(5 minutes @ 300C)

TEHRMOFIT ASSEMBLY PROCEDURE:

1.0

SCOPE

This document outlines the procedure to be followed to obtain immersion resistant multiple wire butt splices using

Thermofit Multi-Wire In-Line Splice Sealing System D-436-42/-43.

2.0 PROCEDURE

a)

Pass the wires to be attached to one barrel through the separate three wire seal. (Item 3) Pass the wires

to be attached to the other barrel through the sealing sleeve from the three hole insert end.

b)

Strip wires 5/16” to 11/32” and crimp into splicer using one of the approved crimping tools (see

below). Care must be taken that the wires remain untwisted between the splice and the three wire seals or the

sealing sleeve cannot be positioned properly.

c)

Position the separate seal as close as possible to the splicer. Hold this piece in position by squeezing

the wires directly behind it, and slide the sealing sleeve over the assembly so that the separate seal is as far

inside the sleeve as possible.

d)

Apply heat, using the recommended heat source, first to the “separate” seal end, and then the other.

Heat should be applied until insert melts and flows axially along the wires.

3.0

RECOMMENDED TOOLS

a. Crimp Tools

Manufacturer

Raychem

Buchanan Electric Products

Daniels manufacturing Company

b. Heat Tools

Heater

Thermogun #500A

Shop Air Heater #CV-4504

Mini-Gun #CV-5300

Model Number

AD-1377

614080

OT-609

Reflector

TG-14

991180

991319

Heater should be operated to give an air stream temperature of at least 550F.

TE Connectivity

305 Constitution Drive

Menlo Park, CA 94025, USA

UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.

INCHES DIMENSIONS ARE BETWEEN BRACKETS.

TOLERANCES:

ANGLES: N/A

TE Connectivity reserves the right to amend this

0.00 N/A

drawing at any time. Users should evaluate the

0.0 N/A

ROUGHNESS IN

suitability of the product for their application.

0 N/A

MICRON

DRAWN BY:

REPLACES:

DCR NUMBER:

TITLE :

Raychem

Products

DOCUMENT NO.:

DATE:

IN-LINE SPLICE SEALING

SYSTEM, MULTI-WIRE

D-436-42/-43

DOC ISSUE:

15-Apr-11

PROD. REV.

SCALE:

SIZE:

2

SHEET:

M. FORONDA

N/A

D001303

SEE TABLE

None

A

4 of 4

If this document is printed it becomes uncontrolled. Check for the latest revision.