General Description, Cont’d,
sealed co-fired ceramic 66 pin, 1.08" sq
PGA or a 68 lead, .88" sq Ceramic Gull
Wing CQFP package for operation over the
temperature range of -55°C to +125°C and
military environment.
second. Erase is accomplished by
executing the erase command sequence.
This will invoke the Embedded Erase
Algorithm which is an internal algorithm
that automatically preprograms the array, (if
it is not already programmed before)
executing the erase operation. During
erase, the device automatically times the
erase pulse widths and verifies proper cell
margin.
Each flash memory die is organized as
128KX8 bits and is designed to be
programmed in-system with the standard
system 5.0V Vcc supply. A 12.0V VPP is
not required for write or erase operations.
The MCM can also be reprogrammed with
standard EPROM programmers (with the
proper socket).
Each die in the module or any individual
sector of the die is typically erased and
verified in 1.3 seconds (if already
completely preprogrammed).
The standard ACT-F128K32 offers
access times between 60ns and 150ns,
Each die also features a sector erase
architecture. The sector mode allows for
allowing
operation
of
high-speed
microprocessors without wait states. To 16K byte blocks of memory to be erased
eliminate bus contention, the device has
separate chip enable (CE) and write enable
(WE). The ACT-F128K32 is command set
compatible with JEDEC standard 1 Mbit
EEPROMs. Commands are written to the
and reprogrammed without affecting other
blocks. The ACT-F128K32 is erased when
shipped from the factory.
The device features single 5.0V power
supply operation for both read and write
command
register
using
standard
functions.
lnternally
generated
and
microprocessor write timings. Register
contents serve as input to an internal
state-machine which controls the erase and
programming circuitry. Write cycles also
internally latch addresses and data needed
for the programming and erase operations.
regulated voltages are provided for the
program and erase operations. A low VCC
detector
automatically
inhibits
write
operations on the loss of power. The end of
program or erase is detected by Data
Polling of D7 or by the Toggle Bit feature on
D6. Once the end of a program or erase
cycle has been completed,-+ the device
internally resets to the read mode.
Reading data out of the device is similar
to reading from 12.0V Flash or EPROM
devices. The ACT-F128K32 is programmed
by executing the program command
sequence. This will invoke the Embedded
Program Algorithm which is an internal
algorithm that automatically times the
program pulse widths and verifies proper
cell margin. Typically, each sector can be
programmed and verified in less than 0.3
All bits of each die, or all bits within a
sector of
a
die, are erased via
Fowler-Nordhiem tunneling. Bytes are
programmed one byte at a time by hot
electron injection.
DESC Standard Military Drawing (SMD)
numbers are released.
2
Aeroflex Circuit Technology
SCD1667 REV A 4/28/97 Plainview NY (516) 694-6700
AEROFLEX [ AEROFLEX CIRCUIT TECHNOLOGY ]
