Data Sheet, Rev. 3
June 2001
FW802A Low-Power PHY
IEEE*
1394A-2000
Two-Cable Transceiver/Arbiter Device
Distinguishing Features
I
I
Supports PHY pinging and remote PHY access
packets.
Fully supports suspend/resume.
Supports PHY-link interface initialization and reset.
Supports 1394a-2000 register set.
Supports LPS/link-on as a part of PHY-link inter-
face.
Supports provisions of
IEEE
1394-1995
Standard
for a High Performance Serial Bus.
Fully interoperable with
FireWire
†
implementation
of
IEEE
1394-1995.
Reports cable power fail interrupt when voltage at
CPS pin falls below 7.5 V.
Separate cable bias and driver termination voltage
supply for each port.
Meets
Intel
‡
Mobile Power Guideline 2000.
Compliant with
IEEE
Standard 1394a-2000, IEEE
Standard for a High Performance Serial Bus
Amendment 1.
Low-power consumption during powerdown or
microlow-power sleep mode.
Supports extended BIAS_HANDSHAKE time for
enhanced interoperability with camcorders.
While unpowered and connected to the bus, will not
drive TPBIAS on a connected port even if receiving
incoming bias voltage on that port.
Does not require external filter capacitors for PLL.
Does not require a separate 5 V supply for 5 V link
controller interoperability.
Interoperable across 1394 cable with 1394 physical
layers (PHY) using 5 V supplies.
Interoperable with 1394 link-layer controllers using
5 V supplies.
1394a-2000 compliant common mode noise filter
on incoming TPBIAS.
Powerdown features to conserve energy in battery-
powered applications include:
— Device powerdown pin.
— Link interface disable using LPS.
— Inactive ports power down.
— Automatic microlow-power sleep mode during
suspend.
Interface to link-layer controller supports Annex J
electrical isolation as well as bus-keeper isolation.
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
Other Features
I
I
I
I
64-pin TQFP package.
Single 3.3 V supply operation.
Data interface to link-layer controller provided
through 2/4/8 parallel lines at 50 Mbits/s.
25 MHz crystal oscillator and PLL provide transmit/
receive data at 100 Mbits/s, 200 Mbits/s, and
400 Mbits/s, and link-layer controller clock at
50 MHz.
Node power-class information signaling for system
power management.
Multiple separate package signals provided for ana-
log and digital supplies and grounds.
I
I
I
I
Features
I
I
Provides two fully compliant cable ports at
100 Mbits/s, 200 Mbits/s, and 400 Mbits/s.
Fully supports OHCI requirements.
Supports arbitrated short bus reset to improve
utilization of the bus.
Supports ack-accelerated arbitration and fly-by con-
catenation.
Supports connection debounce.
Supports multispeed packet concatenation.
I
I
*
IEEE
is a registered trademark of The Institute of Electrical and
Electronics Engineers, Inc.
†
FireWire
is a registered trademark of Apple Computer, Inc.
‡
Intel
is a registered trademark of Intel Corporation.
I
I
I