IEC/EN/DIN EN 60747-5-2 Insulation Related Characteristics (HCPL-2300 Option 060 only)
Description
Symbol
Characteristic
Units
Installation classification per DIN VDE 0110/1.89, Table 1
for rated mains voltage ≤300 V rms
for rated mains voltage ≤450 V rms
I-IV
I-III
Climatic Classification
55/85/21
2
Pollution Degree (DIN VDE 0110/1.89)
Maximum Working Insulation Voltage
VIORM
VPR
630
V peak
V peak
Input to Output Test Voltage, Method b*
VIORM x 1.875 = VPR, 100% Production Test with tm = 1 sec,
Partial Discharge < 5 pC
1181t
Input to Output Test Voltage, Method a*
VIORM x 1.5 = VPR, Type and sample test, tm = 60 sec,
Partial Discharge < 5 pC
VPR
945
V peak
Highest Allowable Overvoltage*
VIOTM
6000
V peak
(Transient Overvoltage, tini = 10 sec)
Safety Limiting Values
(Maximum values allowed in the event of a failure,
also see Figure 11, Thermal Derating curve.)
Case Temperature
Input Current
Output Power
TS
IS,INPUT
PS,OUTPUT
175
230
600
°C
mA
mW
Insulation Resistance at TS, VIO = 500 V
RS
≥109
Ω
*Refer to the front of the optocoupler section of the current catalog, under Product Safety Regulations section, IEC/EN/DIN EN 60747-5-2, for a
detailed description.
Note:
Isolation characteristics are guaranteed only within the safety maximum ratings which must be ensured by protective circuits in application.
Absolute Maximum Ratings
(No Derating Required up to 55°C)
Description
Min.
Typ.
Max.
Units
TS
Storage Temperature
Operating Temperature
-55°C
-40°C
+125°C
+85°C
TA
Lead Solder Temperature
(1.6 mm below seating plane)
260°C for 10 s
5 mA[2]
max
Average Forward Input Current
Reverse Input Voltage
- IF
VR
VCC
VRL
IO
3.0 V
7.0 V
VCC
Supply Voltage
0 V
Pull-Up Resistor Voltage
Output Collector Current
Input Power Dissipation
Output Collector Power Dissipation
Output Collector Voltage
-0.5 V
-25 mA
25 mA
10 mW
40 mW
PI
PO
VO
-0.5 V
18 V
Infrared and Vapor Phase Reflow Temperature (Option #300) see Fig. 1, Thermal Profile
6
AVAGO [ AVAGO TECHNOLOGIES LIMITED ]
