ISO-CMOS
If bit 6 of the Control Register is 0, then bits 2 and 0
of each Connection Memory High location function
normally (see Fig. 5). If bit 2 is 1, the associated ST-
BUS output channel is in Message Mode; i.e., the
byte in the corresponding Connection Memory Low
location is transmitted on the stream at that channel.
Otherwise, one of the bytes received on the serial
inputs is transmitted and the contents of the
Connection Memory Low define the ST-BUS input
stream and channel where the byte is to be found
(see Fig. 6).
If the ODE pin is low, then all serial outputs are high-
impedance. If it is high and bit 6 in the Control
Register is 1, then all outputs are active. If the ODE
pin is high and bit 6 in the Control Register is 0, then
the bit 0 in the Connection Memory High location
enables the output drivers for the corresponding
individual ST-BUS output stream and channel. Bit
0=1 enables the driver and bit 0=0 disables it (see
Fig. 5).
MT8981D
The MT8964 filter/codec in Fig. 7 receives and
transmits digitised voice signals on the ST-BUS input
D
R
, and ST-BUS output D
X
, respectively. These
signals are routed to the ST-BUS inputs and outputs
on the top MT8981, which is used as a digital speech
switch.
The MT8964 is controlled by the ST-BUS input D
C
originating from the bottom MT8981, which
generates the appropriate signals from an output
channel in Message Mode.
This architecture
optimises the messaging capability of the line circuit
by building signalling logic, e.g., for on-off hook
detection, which communicates on an ST-BUS
output. This signalling ST-BUS output is monitored
by a microprocessor (not shown) through an ST-BUS
input on the bottom MT8981.
Fig. 8 shows how a simple digital switching system
may be designed using the ST-BUS architecture.
This is a private telephone network with 128
extensions which uses a single MT8981 as a speech
switch and a second MT8981 for communication with
the line interface circuits.
A larger digital switching system may be designed by
cascading a number of MT8981s. Fig. 9 shows how
four MT8981s may be arranged in a non-blocking
configuration which can switch any channel on any
of the ST-BUS inputs to any channel on the ST-BUS
outputs.
Applications
Use in a Simple Digital Switching System
Fig. 7 and 8 show how MT8981s can be used with
MT8964s to form a simple digital switching system.
Fig. 7 shows the interface between the MT8981s and
the filter/codecs. Fig. 8 shows the position of these
components in an example architecture.
STo0
STi0
8981 used
as
speech
switch
MT8981
D
X
D
R
D
C
STo0
STi0
MT8964
Filter/Codec
Signalling
Logic
Line Driver
and
2- to 4-
Wire
Converter
8981 used
in message
mode for
control and
signalling
Line Interface Circuit with 8964 Filter/Codec
MT8981
Figure 7 - Example of Typical Interface between 8981s and 8964s for Simple Digital Switching System
2-23
MITEL [ MITEL NETWORKS CORPORATION ]
