M58LT256JST, M58LT256JSB
Configuration Register
6.3
Wait polarity bit (CR10)
The wait polarity bit sets the polarity of the Wait signal used in synchronous burst read
mode. During synchronous burst read mode the Wait signal indicates whether the data
output are valid or a WAIT state must be inserted.
When the Wait polarity bit is set to ‘0’, the Wait signal is active Low. When the wait polarity
bit is set to ‘1’ the Wait signal is active High.
6.4
Data output configuration bit (CR9)
The data output configuration bit configures the output to remain valid for either one or two
clock cycles during synchronous mode.
When the data output configuration bit is ’0’ the output data is valid for one clock cycle, and
when it is ’1’, the output data is valid for two clock cycles.
The data output configuration bit must be configured using the following condition:
●
t
K
> t
KQV
+ t
QVK_CPU
t
K
is the clock period
t
QVK_CPU
is the data setup time required by the system CPU
t
KQV
is the clock to data valid time.
where
●
●
●
If this condition is not satisfied, the data output configuration bit should be set to ‘1’ (two
clock cycles). Refer to
6.5
Wait configuration bit (CR8)
The wait configuration bit controls the timing of the Wait output pin, WAIT, in synchronous
burst read mode.
When WAIT is asserted, data is not valid, and when WAIT is de-asserted, data is valid.
When the wait configuration bit is Low (set to ’0’), the wait output pin is asserted during the
WAIT state. When the wait configuration bit is High (set to ’1’), the wait output pin is
asserted one data cycle before the WAIT state.
6.6
Burst type bit (CR7)
The burst type bit determines the sequence of addresses read during synchronous burst
reads.
The burst type bit is High (set to ’1’), as the memory outputs from sequential addresses only.
See
for the sequence of addresses output from a given
starting address in sequential mode.
39/108
NUMONYX [ NUMONYX B.V ]
