1000W Single Output Power Supply
Function Description of CN50
RSP-1000
series
Pin No. Function Description
Positive sensing. The +S signal should be connected to the positive terminal of the load. The +S and -S leads should be twisted in pair to
1
+S
minimize noise pick-up effect. The maximum line drop compensation is 0.5V.
2
3
4
5
6
7
8
9
10
11,12
-S
Negative sensing. The -S signal should be connected to the negative terminal of the load. The -S and +S leads should be twisted in pair to
minimize noise pick-up effect. The maximum line drop compensation is 0.5V.
G-AUX Auxiliary voltage output ground. The signal return is isolated from the output terminals (+V & -V).
Auxiliary voltage output, 4.6~5.25V, referenced to pin 3(G-AUX). The maximum load current is 0.5A. This output has the built-in oring
5V-AUX diodes and is not controlled by the "remote ON/OFF control".
Open collector signal, referenced to pin11,12(GND). Low when PSU turns on. The maximum sink current is 10mA and the maximum
DC_OK external voltage is 5.6V.
ON/OFF Turns the output on and off by electrical or dry contact between pin 6 ( ON/OFF) and pin 2 (-S). Short: Power ON, Open: Power OFF.
Current sharing signal. When units are connected in parallel, the CS pins of the units should be connected to allow current balance
CS
between units.
Vco
Vci
Vca
GND
Short connecting between Vco (pin8) and Vca (pin10) if output voltage trim function is not used.
Connect to external DC voltage source for output voltage triming, referenced to pin 2 (-S). Output voltage can be trimmed between
40 ~ 110% of the rated output voltage.
Connect to external resistor (1/8W) for output voltage triming. Output voltage can be trimmed between 40 ~ 110% of the rated output
voltage. Please refer to function manual for details.
These pins connect to the negative terminal (-V). Return for DC_OK Signal output.
Function Manual
1."Remote ON/OFF" and "Output voltage trim" functions are not used.
The power supply unit will have no output if the shorting connector (accessory comes along with the PSU) is not assembled. It contains
two shorting wires : one is from ON/OFF (pin6) to -S (pin2) and the other is from Vco (pin8) to Vca (pin10).
+V
1 11
2 12
-V SVR51 CN50
TB1
1
CN50
AUXG DC_OK
CS
Vci
Vca
11
GND
GND
12
LOAD
+
-
+S
-S
AUX ON/OFF Vco
Fig 1.1
2
(Shorting connector)
File Name:RSP-1000-SPEC 2006-11-21
ELECTRONIC COMPONENTS
RSG
■
RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany
Tel. +49 69 984047-0 Fax +49 69 984047-77 info@rsg-electronic.de
www.rsg-electronic.de
■
■
■
■
■
Änderungen vorbehalten / subject to change without notice