PIC18F2480/2580/4480/4580
18.0
MASTER SYNCHRONOUS
SERIAL PORT (MSSP)
MODULE
Master SSP (MSSP) Module
Overview
18.3
SPI Mode
The SPI mode allows 8 bits of data to be synchronously
transmitted and received simultaneously. All four
modes of SPI are supported. To accomplish
communication, typically three pins are used:
• Serial Data Out (SDO) – RC5/SDO
• Serial Data In (SDI) – RC4/SDI/SDA
• Serial Clock (SCK) – RC3/SCK/SCL
Additionally, a fourth pin may be used when in a Slave
mode of operation:
• Slave Select (SS) – RA5/AN4/SS/HLVDIN
module when operating in SPI mode.
18.1
The Master Synchronous Serial Port (MSSP) module is
a serial interface, useful for communicating with other
peripheral or microcontroller devices. These peripheral
devices may be serial EEPROMs, shift registers,
display drivers, A/D Converters, etc. The MSSP
module can operate in one of two modes:
• Serial Peripheral Interface (SPI)
• Inter-Integrated Circuit (I
2
C)
- Full Master mode
- Slave mode (with general address call)
The I
2
C interface supports the following modes in
hardware:
• Master mode
• Multi-Master mode
• Slave mode
FIGURE 18-1:
MSSP BLOCK DIAGRAM
(SPI MODE)
Internal
Data Bus
Read
SSPBUF reg
Write
18.2
Control Registers
SSPSR reg
SDI
bit 0
Shift
Clock
The MSSP module has three associated registers.
These include a status register (SSPSTAT) and two
control registers (SSPCON1 and SSPCON2). The use
of these registers and their individual configuration bits
differ significantly depending on whether the MSSP
module is operated in SPI or I
2
C mode.
Additional details are provided under the individual
sections.
SDO
SS Control
Enable
SS
Edge
Select
2
Clock Select
SSPM<3:0>
SMP:CKE
4
TMR2 Output
2
2
Edge
Select
Prescaler T
OSC
4, 16, 64
(
)
SCK
Data to TX/RX in SSPSR
TRIS bit
©
2009 Microchip Technology Inc.
DS39637D-page 191
MICROCHIP [ MICROCHIP TECHNOLOGY ]
