The Same Ease-of-Use as the E3X-DA-N
Environmentally Friendly Design
The E3X-DA-S uses OMRON's own
Environmentally friendly features are
essential in truly high-performance products.
Simplified Connector Design
Reduced Power Wiring Saves Space
simplified wiring connectors that
were introduced with the E3X-DA-N.
Up to 16 Amplifiers can be connected.
<Using 5 Amplifiers>
Connector models
Relay connectors
not required.
Power is supplied
from the master
Amplifier Unit to
the slave Amplifier
Units through the
Master Connector.
Patent Pending
Japan patent number 3266198
First in the industry
1 Materials containing lead have been completely eliminated.
7 cables
Streamlined
wiring
In Amplifiers with Connectors, the power supply is dis-
tributed to slave connectors through a single master
connector. This design has three major advantages.
Eliminate the installation time, cost, and
space associated with relay connectors.
Prewired models
The Fiber Sensor is the first in the industry
to use environmentally friendly lead-free
solder.
Separate power
lines and output
lines are required
for each Amplifier.
Optical
commun-
ications
1. Wiring time is significantly reduced.
15 cables
No lead!
Pb
2. Relay connectors are unnecessary, so wiring takes up less space.
3. Storage and maintenance are simpler because it isn't necessary to distin-
guish between master connector and slave connectors on the Amplifier.
Power supply pin
Master connector
Relay connectors
Slave connector
This ECO label is indicated on produts
that meet the environmental standards
established by OMRON.
Optical communications
prevents mutual interference.
Mutual interference is prevented with optical com-
munications, so up to 10 Amplifiers can be mount-
ed together.
(The number of Amplifiers depends on the operating conditions.)
Optical
communi-
cations
2 The digital display can be turned OFF or dimmed during operation. Eco-mode
Up to 10 Amplifiers
Close-mounting of up to 10 Sensors
When the digital display is viewed infre-
quently during operation, current con-
Display not lit.
Dimmed display
sumption can be reduced by dimming the
display or turning it OFF entirely.
The display will light up again automatical-
ly when an operation key is touched. (Eco-
mode can be set from the Mobile Console
only.)
Zero reset function immediately
resets the digital display to 0.
With Workpiece
Without Workpiece
Lights up if an
operation is
performed.
Lights up if an
operation is
performed.
During operation
(After 30 s without
an operation)
During operation
(After 30 s without
an operation)
Patent Pending
Japan patent number 3255229
Shift
Zeroo resseett
The zero reset function can immediately reset the
digital display to 0 at any time. By setting the ref-
erence value to 0, the threshold value can be set
while monitoring differences in incident light lev-
els. The threshold value will also shift simultane-
ously when the zero reset button is pressed.
Incident level
difference = 700
Display reset to 0.
Threshold level
set to 350.
3
Cable disposal is not required during maintenance.
In addition to saving space and reducing
wiring time, the new connector design
eliminates the need to dispose of cables
together with the Amplifiers.
Reversible Digital Display (Reverse Mode)
The digital display can be reversed to match the
Amplifier's mounting direction.
Standard mode
Selectable
Cable disposal is not necessary.
Reverse mode
8
9