Revision 1.16 – July 19, 2006
440GR – PPC440GR Embedded Processor
Preliminary Data Sheet
Table 12. V Supply Power Dissipation
DD
Frequency (MHz)
+1.4V
0.83
0.91
1.09
1.62
+1.5V
1.00
1.09
1.28
1.93
+1.6V
1.24
1.35
1.57
2.38
Unit
W
Notes
333
1
1
1
1
400
W
533
W
667
W
Notes:
1. Power is based on VDD specified in the table and TC = max. specified in Table 9 on page 59, while running Linux and a test application
that exercises each core with representative traffic.
Table 13. DC Power Supply Loads
Parameter
Symbol
Typical
1250
10
Maximum
Unit
mA
mA
mA
mA
mA
Notes
V
DD (1.5V) active operating current
IDD
1900
100
600
5
OVDD (3.3V) active operating current
SVDD (2.5V) active operating current
AVDD (1.5V) input current
IODD
ISDD
460
IADD
3.2
1
1
SAVDD (1.5V) active operating current
ISADD
6.05
10
Notes:
1. See “Absolute Maximum Ratings” on page 58 for filter recommendations.
2. The maximum current values listed above are not guaranteed to be the highest obtainable. These values are dependent on many factors
including the type of applications running, clock rates, use of internal functional capabilities, external interface usage, case temperature,
and the power supply voltages. Your specific application can produce significantly different results. VDD current and power are primarily
dependent on the applications running and the use of internal chip functions (DMA, PCI, Ethernet, and so on). OVDD current and power
are primarily dependent on the capacitive loading, frequency, and utilization of the external buses.
3. Typical current is estimated at 667MHz with VDD = +1.5V, OVDD = +3.3V, SVDD = +2.5V, and TC = +85°C, while running Linux and a test
application that exercises each core with representative traffic..
4. Maximum current is estimated at 667MHz with VDD = +1.6V, OVDD = +3.6V, SVDD = +2.7V, and TC = +85°C, and best-case process
(which drives worst-case power), while running Linux and a test application that exercises each core with representative traffic.
Test Conditions
Output
Pin
Clock timing and switching characteristics are specified in accordance with operating
conditions shown in the table “Recommended DC Operating Conditions.” AC
50pF
specifications are characterized with V = 1.5V, T = +85°C and a 50pF test load as
DD
C
shown in the figure to the right.
AMCC Proprietary
61
AMCC [ APPLIED MICRO CIRCUITS CORPORATION ]
