Data
Sheet
(Pre limin ar y)
9.11
Deep Power Down (DP)
The Deep Power Down (DP) command provides the lowest power consumption mode of the device. It is
intended for periods when the device is not in active use, and ignores all commands except for the Release
from Deep Power Down (RES) command.
The DP mode therefore provides the maximum data protection
against unintended write operations.
The standard standby mode, which the device goes into automatically
when CS# is high (and all operations in progress are complete), should generally be used for the lowest
power consumption when the quickest return to device activity is required.
The host system must drive CS# low, and then write the DP command on SI. CS# must be driven low for the
entire duration of the DP sequence. The command sequence is shown in
and
The host system must drive CS# high after the device has latched the 8th bit of the DP command, otherwise
the device does not execute the command. After a delay of t
DP,
the device enters the DP mode and current
reduces from I
SB
to I
DP
(see
Once the device has entered the DP mode, all commands are ignored except the RES command (which
releases the device from the DP mode). The RES command also provides the Electronic Signature of the
device to be output on SO, if desired (see sections
and
DP mode automatically terminates when power is removed, and the device always powers up in the standard
standby mode. The device rejects any DP command issued while it is executing a program, erase, or Write
Status Register operation, and continues the operation uninterrupted.
Figure 9.11
Deep Power Down (DP) Command Sequence
CS#
tDP
Mode
3
0
1
2
3
4
5
6
7
SCK
Mode 0
Command
SI
Hi-Z
SO
Standby
Mode
Deep Power-down Mode
24
S25FL032A
S25FL032A_00_C0 September 1, 2006
SPANSION [ SPANSION ]
